Aligning color across technologies

Mark Andy and CMC show how standardization cuts waste and makeready.

L-R: Łukasz Chruśliński, European sales manager at Mark Andy and Małgorzata Szczotka, owner of CMC.

Mark Andy and the color management consultancy CMC have shown printers in Warsaw how standardization can keep color consistent between flexo and hybrid presses while cutting waste and makeready time, at workshops held at the Mark Andy European Technology Center.

The problem is familiar to any converter running more than one printing technology: the same job can come out differently on different presses, which costs time in makeready, material in waste and confidence in repeat runs. The workshops, 'Standardization Connects Technologies. You Print, We Care', asked how color consistency can be ensured across technologies while reducing waste and increasing repeatability. Several dozen printers attended, including customers of both companies. Lukasz Chruslinski, European sales manager at Mark Andy, and Malgorzata Szczotka, owner of CMC, opened the event.

Mark Andy

'Standardization does not eliminate differences between technologies. It allows us to measure, describe and control them. Our goal is to establish production conditions in which the results are predictable and repeatable, regardless of a technology used. It impacts not only on print quality, but also shorter makeready times, less waste and improved production profitability,' said Szczotka.

CMC's answer is a step-by-step process: audits and assessments of press condition, parameter selection and calibration, control procedures and ongoing verification of print quality. It centers on the G7 Idealliance method, which controls tonal response and grey balance and brings different processes toward a common color target while allowing for their technological differences. CMC stressed that much of the work happens on the production floor rather than in prepress, because press stability, printing parameters, substrate control and adherence to procedures decide whether quality holds across repeat runs.

Participants saw this on two Mark Andy presses, the flexo Evolution Series E5 and the hybrid Digital Series HD HighSpeed 1200, running sample labels submitted by attendees rather than laboratory test samples. For flexo, CMC highlighted the selection and checking of anilox rollers, ink transfer stability, halftone dot characteristics and correction curves. For digital, it discussed control of ink amount, linearization, ICC profiling and adjusting press parameters to the substrate and job. Control measurements compared the prints with a certified proof to check conformity objectively.

Mark Andy CMC

Measurement was a second theme. CMC, a technology partner of X-Rite, showed how color measurement and reporting can replace subjective print assessment with data, record production parameters and link color control to ink mixing, ink formulation and leftover ink management. Chruslinski said that preparation and control of the whole process matter as much as the equipment. 'Modern technology creates the conditions for achieving high quality and productivity, but proper preparation and control of the entire production process are equally important. This is why we pay such importance to practical education and the exchange of knowledge with experts and customers,' he added.

Andrzej Jablonski, who represents IST Metz in Poland, a company Mark Andy recently began working with globally, also spoke on UV and UV LED curing, including the modular swap4cure concept. An IST system was installed on the E5 used in the workshops.